Skip to main content
Fig. 1 | BMC Oral Health

Fig. 1

From: Computerized dynamic occlusal analysis and its correlation with static characters in post-orthodontic patients using the T-Scan system and the ABO objective grading system

Fig. 1

The analysis of static model on full adjustment articulator (PROTAR evo7, Kavo, German) (a). The uniform measuring gauge of the ABO-OGS system (b). This portion of the gauge was used to measure discrepancies in alignment, overjet, occlusal contacts, interproximal contacts, and occlusal relationships. It is in 1 mm increments and the width of the gauge is 0.5 mm (c). The measurement of occlusal contact on the labial side using the specific gauge (d). The ABO measurement tool used was purchased from the ABO official website: AmericanBoardOrtho.com. The manufacturer information of the measuring tape is: Bender Support, Bender.Inc., Fenton, USA

Back to article page

BMC Oral Health

ISSN: 1472-6831

Contact us