Study group | Ceramic surface treatment | Dentin surface treatment | Cementation procedure |
---|---|---|---|
IPS e.max CAD (groups LiDi/LC and LiDi/DC) | Etch with 9% hydrofluoric acid for 10 s | Etch with 37.5% phosphoric acid for 10 s | Apply a 2 mm diameter drop of NX3 Nexus cement onto the center of dentin surface |
Rinse thoroughly with water | Rinse thoroughly with water | Place the ceramic slice on top of the cement | |
Air dry | Gentle air flush for 10 s | Apply finger pressure until excess cement appears around the tooth margins | |
Apply silane for 60 s | Apply OptiBond Solo for 15 s | Light curea for 2 s | |
Air dry | Air thin for 3 s | Remove the excess by explorer then light curea 20 s on each surface of the assembly | |
Katana Zirconia (groups Zr/LC and Zr/DC) | Sandblast with 50 μm aluminum oxide powder at 2 bar/30 psi | Light curea for 10 s | |
Ultrasonic clean | |||
Air dry |